Easy Hot Water System Maintenance Tips

Wouldn’t life be much easier if you have a reliable hot water system at home?

With numerous models of hot water systems available in the market nowadays, you can expect each to come with energy-efficient features that are hard to miss.  

Oftentimes, people tend to just take their hot water system for granted until it breaks down.

Fortunately, you do not have to learn things the hard way.

Ensure you do not experience the inconvenience of having to deal with a malfunctioning hot water system by keeping the following in mind.

Tip 1: Checking the Pressure Valve

Gas and electric hot water heater systems come equipped with a safety device commonly known as pressure relief valve. When the tank gets overpressurized, the relief valve works by opening and releasing pressure in the process. Suffice it to say, a malfunctioning relief valve can have serious repercussions as it can cause the system to overpressurize and eventually explode. 

Steps to Take When Checking the Pressure Valve

  1. Make sure your electric water heater system is turned off and not connected to the power supply. If you are using gas hot water heater, ensure the gas switch is turned to pilot.
  2. Make certain that the cold water inlet connected to the water heater is also shut off.
  3. Place an empty bucket to where the pressure relief valve is – when you release the water from there, there should be no drippings on the ground.
  4. Release the trip level of the valve slowly to make sure pressure is released first before the valve opens.

Tip 2: Flushing your Hot Water Heater Tank

If you are going to start cleaning up the tank, the first thing you need to do is flush. This is done in order to release any sediment build-up that can lower your water heater’s energy efficiency. Sediments can also clog your water lines so removal is deemed a must.

Steps in Cleaning or Flushing the Tank

After making sure both the electricity and the cold water inlet have been turned off, you need to put on protective gear so you can start the flushing process.

  1. Connect a garden hose to the tank’s drain valve to let the water from the tank out.
  2. Try to find a place where you can safely drain the water from the hose. Make sure it is an area away from children or pets as you will be releasing scalding hot water.
  3. Once the relief valve is opened, you also need to make sure the drain valve is unlocked. Doing so will help guarantee the tank will be drained completely. Also, this will help warrant the sediments inside the tank will be thoroughly removed.
  4. Once done, close the tank drain valve and disconnect the garden hose. You can now proceed to close the pressure relief valve right after.
  5. After which, make sure all the hot water spigots in your house are opened and the cold water inlet is turned back on.
  6. As soon as the water starts flowing, make sure to close the hot water spigot.
  7. Once all the spigots are closed, you can now turn the electricity back on.  In the case of the gas hot water heater, you can now turn the gas switch on.

Check for Leaks and Drips

Usually, leaks are attributed to faulty water supply connections or pipes. In line with this, you need to make sure you use only sturdy materials. You also need to make it a point to employ the right methods especially when checking your work. As an added note, compression fittings are way easier to use if you prefer do-it-yourself work.

Remember that just like any equipment in your home, your hot water heater system needs to be properly maintained. Having a professional perform routine checks is deemed a worthy investment as it can help guarantee years of hassle-free usage and substantial savings in the long run.